Today I started out by using the new blue prints to create my model without having the porch be apart of the structure. But once I started cutting, I got a little detracted and cut a little part of my finger off. But it was okay. It was a little bit and I got a band-aid and was good to go. That was the only downside of the day. Once I started working on the model again, and putting up the walls, my mentor taught me a trick to use to make sure that the walls go up completely straight by putting a straight edge against the wall. This made it a lot easier to glue. I ran int o a issue with the pop outs that are part of the living room because the roof didn't match up with the side.I hope that tomorrow I can put the roof porches, and stairs up because then I will have completed my Link project, and will possibly be able to use the architect design program and will be able to design some of my own buildings.